Introduction; General Information - Zeiss Stemi 305 Mode D'emploi

ZEISS
1

INTRODUCTION

1.1

General information

The stereo microscope Stemi 305 cam has been designed, produced and tested in compliance with the
standards DIN EN 61010-1 (IEC 61010-1) and IEC 61010-2-101 "Safety Requirements for Electrical
Measuring, Control and Laboratory Equipment".
The power unit used corresponds to DIN EN 60950-1 (IEC 60950-1) "Information technology
equipment - Safety".
This device complies with the requirements of the EC Directive 98/79/EC Annex 1 regarding ivd products,
EC RoHS Directive 2011/65/EG (RoHS) and EC Directive 1999/5/EG (R&TTE, Radio Equipment &
Telecommunications Terminal Equipment) and bears the
This operating manual contains information and warnings to be observed by the operator.
The devices must be disposed of in compliance with the WEEE Directive 2012/19/EC.
The warning and information symbols explained below are used in these operating instructions:
CAUTION
This symbol identifies a risk for the user.
CAUTION
LED risk group 2 acc. to DIN EN 62471:2009 Optical radiation is emitted.
Do not look into the beam. This may damage your eyes.
CAUTION: High-energy UV radiation!
Risk of damage to eyes and skin!
CAUTION
Hot surface!
CAUTION
Remove the mains plug before any intervention in the instrument!
ATTENTION
This symbol identifies a risk for the device or system.
NOTICE
This symbol identifies a note which must be given special attention.
2
INTRODUCTION
General information
- mark.
435063-9044-008
Stereo microscope
Stemi 305 cam
03/2015