Start A Scan - HP SCANJET N6350 Guide De Démarrage Rapide

Chapter 2
5. Adjust the paper guides to the width of the documents. Take care not to overtighten
the guides, which can restrict paper feeding, but make sure that the paper guides
touch the edges of the documents.
6. Gently push the stack forward to activate the tray sensor.
See also
"Start a scan" on page 16

Start a scan

This section describes the methods you can use to start a scan.
Use the Scan button
To scan using the Scan (
1. Load the originals.
2. If your scanner LCD displays computer names:
a. Use
press OK.
b. If prompted, enter your PIN and then press OK.
3. Use
NOTE: If the scanner LCD indicates there are no scan shortcuts on the scanner,
you must upload the scan shortcuts before you can scan.
4. Press the Scan (
scan to the computer.
NOTE: If you want to preview and edit your scan before sending it, start the scan
from the HP scanning software.
See also
• "Upload default scan shortcuts to the scanner" on page 6
• "Use the HP scanning software" on page 17
16 HP Scanjet N6350
) button on the scanner, follow these steps:
and on the scanner control panel to select your computer, and then
and on the scanner control panel to select the scan shortcut.
) button on the scanner control panel. The scanner sends the