Set The Language; Prepare The Scanner For Use - HP SCANJET N6350 Guide De Démarrage Rapide

Chapter 1
Use the USB cable that came with the scanner to connect the scanner to your computer.
1. Connect the square end of the USB cable to the scanner.
2. Connect the rectangular end of the USB cable to a USB port on the back of your
computer.

Set the language

The first time you turn on the scanner, after the initial warm-up you are prompted to select
the language to be shown on the LCD.
To select the language, follow these steps:
1. Use
2. Press OK to select the language, and then press OK again to confirm your selection.

Prepare the scanner for use

You must complete one of the following tasks before you can use the Scan (
on the scanner control panel. The task you complete depends upon the scanning software
solution that you chose.
Upload default scan shortcuts to the scanner
The HP scanning software that shipped with your scanner includes default scan shortcuts.
If you installed the HP scanning software, follow these steps to upload the default scan
shortcuts to your scanner:
1. Double-click the HP Scanning icon on your desktop; if you are connected to more
than one HP Scanjet N6350, select the scanner to which you wish to upload scan
shortcuts.
2. On the HP Scanning shortcuts dialog box, select Scan To...Setup from the
Options drop-down menu.
6 HP Scanjet N6350
and until the language you want appears.
) button