Installation; Operation - Inventum MN3018C Manuel D'utilisation

During this function, the appliance is working and the turntable turns to the start position. The display shows
.
The appliance stops when the function is finished.
When you open the door or push the stop button during the function, the appliance goes into standby.
Note:
The turntable reset function only works for a completed cooking process. If you pause the appliance or
open the door during the cooking, the function does not work.
Note:
After the turntable reset function finishes, the turntable can deviate 30° from the start position.
4

Installation

UNPACKING
1. Remove the packaging.
2. Examine the appliance for damage.
INSTALLING THE APPLIANCE
1. Place the appliance on a flat and stable surface.
2. Place the appliance as far away as possible from a radio or television. The microwave energy can cause
interferences with these appliances.
3. Do not place the appliance near a heat source.
4. Make sure that there is sufficient space available around the appliance for the ventilation openings.
Caution:
Blocking the ventilation openings can cause damage to the appliance.
5. Do not remove the supports of the appliance.
6. Install the appliance according to the dimensions in the figure.
7. Make sure that the back of the appliance is placed against a wall.
Warning:
The wave guide cover inside the appliance divides the microwaves and must never be removed.
5

Operation

PREPARING FOR OPERATION
1. Clean the appliance and the accessories before operation. Use a damp cloth.
SETTING THE CLOCK
Note:
When you plug in the appliance for the first time, the display shows '0:00' and the buzzer sounds one
time.
1. Push the kitchen assistant button. The display shows 'AS-1'.
2. Push the start button to go to the clock setting mode. The display shows '0:00' and the value for hours flashes.
32 • English
(Figure 3)