Sony ExwaveHAD SNC-CS3N Manuel D'installation page 29

Owner's Record
The model and serial numbers are located on
the Top. Record these numbers in the spaces
provided below.
Refer to these numbers whenever you call
upon your Sony dealer regarding this
product.
Model No.
WARNING
To prevent fire or shock hazard, do
not expose the unit to rain or
moisture.
To avoid electrical shock, do not
open the cabinet. Refer servicing to
qualified personnel only.
Power Supply
Caution for U.S.A. and Canada
The SNC-CS3N operates on 24V AC or 12V
DC.
The SNC-CS3N automatically detects the
power.
Use a Class 2 power supply which is UL
Listed (in the U.S.A.) or CSA-certified (in
Canada).
Caution for other countries
The SNC-CS3P operates on 24V AC or 12V
DC.
The SNC-CS3P automatically detects the
power.
Use a power supply which complies with the
safety regulation of the country where the
unit is used.
Serial No.
For customers in the U.S.A. (SNC-
CS3N only)
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference wll not occur in a
particular installation. If this equipment does
cause harmful interference to radio or
television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct
the interference by one or more of the
following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the
equipment and receiver.
– Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
– Consult the dealer or an experienced radio/
TV technician for help.
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate
this equipment.
The shielded interface cable recommended
in this manual must be used with this
equipment in order to comply with the limits
for a digital device pursuant to Subpart B of
Part 15 of FCC Rules.
GB
1
GB