Comments - Ecolab Penguin Foam 1P-CA Mode D'emploi

Descaling procedure
• Turn of the water supply to the
unit.
• Set the unit in rinsing position.
• Fill up the injector with descaling
fluid.
• Turn on the water supply to the
unit.
6
• Screw of the drain plug in the
top of the unit.
15 min
• Leave the descaling fluid in the
unit for min. 15 min.
• Rinse until clean water comes
out of the hose.
2 sek.
• Activate the handle for 2 sec. to
empty the injector for water
• Screw on the drain plug in the
top of the unit.

10. Comments

In places with a low water pressure
or water quantity of the water sup-
ply, it is recommended to replace
the wire mesh in the foam noz-
zle with the additionel wire mesh
enclosed.