Step 4C: Close The Housing; Step 5: Test The System - Abus FUSG50110 Manuel D'installation

Installation

Step 4c: Close the housing

• Close the cover, tighten the cover fixing screws and close the covers of the screws.

Step 5: Test the system

General:
• Test the system fully.
• Check that all connected components function properly.
• Check that the system as a whole responds properly to the connected components.
• Check if the correct notifications are shown on the alarm panel and if the corresponding
reactions are triggered.
You can also test the system when the sounder is open. However, do not leave
Secvest installer mode to do so.
Note
Signal strength
• Signal strength of the indoor sounder on the alarm panel
Installer mode > Test > Signal strengths -> Indoor sounder
Here you can see the signal strengths of the paired indoor sounder.
46 | E N
Image 6