Removing Chuck; Tips And Tricks; Maintenance; Accessories - Metabo BE 6 Notice Originale

17027064_1110 BE 6 BE 10.book Seite 11 Donnerstag, 18. November 2010 1:22 13
7.5 Removing the chuck
Geared chuck (2)
Undo the locking screw. Caution left-handed
thread!
Hold the drill spindle tight with an open-ended
spanner. With a light blow from a rubber hammer,
release the chuck from the inserted chuck key and
unscrew it.
Keyless chuck (3)
Undo the locking screw. Caution left-handed
thread!
Hold the drill spindle tight with an open-ended
spanner. With a light blow from a rubber hammer,
release the chuck from the clamped hexagon
spanner and unscrew it.

8 Tips and Tricks

In the case of deep bores pull the drill bit out of the
bore from time to time in order to remove the bore
dust or shavings.

9 Maintenance

Keyless chuck cleaning:
After prolonged use hold the chuck vertically, with
the opening facing down, and fully open and close
it several times. The dust collected falls from the
opening. Regular use of cleaning spray on the jaws
and jaw openings is recommended.

10 Accessories

Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
For dealers to select the correct accessory, they
need to know the exact model designation of your
power tool.
See page 4.
A Metabox
B Complete drill bit range, see main catalogue
C Screwdriver bit sets, bit holders, bit boxes
D Flexible shaft
E Flap-wheel sander
F Mounted points
G Steel wire end brush
H Steel wire cup brush
I Steel wire rotary brush
For complete range of accessories, see
www.metabo.com or the main catalogue.

11 Repairs

Repairs to electrical tools must be carried out by
qualified electricians ONLY!
The connection cable must only be replaced by
Metabo or an authorised customer service work-
shop.
Metabo electrical tools which require repair may
be sent to a Metabo service centre. For addresses
see www.metabo.com.
Please enclose a description of the fault with the
power tool.
ENGLISH
ENG
11