Maintaining Snowthrower; Sound Pressure Level; Sound Power Level; Vibration Level - Toro 824 Power Shift Manuel De L'utilisateur

23. Never operate snowthrower at high transport
speeds on slippery surfaces. Use care when
backing.

Maintaining Snowthrower

24. Perform only those maintenance instructions
described in this manual. Shut engine off before
performing any maintenance service or
adjustment. Additionally, pull wire off spark
plug and keep wire away from plug to prevent
accidental starting. If major repairs are ever
needed, contact your local Authorized TORO
Service Dealer for assistance.
25. Keep snowthrower in safe operating condition
by keeping nuts, bolts, and screws tight. Check
engine mounting bolts frequently to ensure they
are tight.
26. Do not overspeed the engine by changing
governor settings. Recommended maximum
engine speed is 3500 rpm. To ensure safety and
accuracy, check maximum engine speed (3500
rpm) with a tachometer.
27. Allow engine to cool before storing in an
enclosure such as a garage or storage shed.
NEVER STORE SNOWTHROWER IN
HOUSE (LIVING AREA) OR BASEMENT
BECAUSE GASOLINE AND FUMES ARE
HIGHLY FLAMMABLE, EXPLOSIVE,
AND DANGEROUS IF INHALED. Do not
store snowthrower near any open flame or where
gasoline fumes may be ignited by a spark.
28. When storing the snowthrower for an extended
time—off-season storage or 30 days—drain
gasoline from fuel tank to prevent a potential
hazard. Store gasoline in a safety-approved red
metal container. Remove key from ignition
switch when storing snowthrower. Store key in a
memorable place.
29. At the time of manufacture, the snowthrower
conformed with or exceeded OPEI safety
standards in effect for snowthrowers. Therefore,
to ensure best performance and safety, purchase
genuine TORO replacement parts and
accessories to keep the TORO all TORO.
NEVER USE "WILL FIT" REPLACEMENT
PARTS AND ACCESSORIES.
30. For safety reasons, use only those accessories
and attachments recommended by The TORO
Company to ensure continued safety certification
of the product. Using unapproved accessories
and attachments could contribute to a potential
hazard.

Sound Pressure Level

This unit has a sound pressure at the operator's ear of
91 dB(A), based on measurements of identical
machines per Directive 81/1051/EEC.

Sound Power Level

This unit has a sound power level of 106 LwA, based
on measurements of identical machines per Directive
79/113/EEC.

Vibration Level

This unit has a maximum hand-arm vibration level of
13.8 m/s (model 38546) or 16.2 m/s (model 38559)
based on measurements of identical machines per EN
1033.
GB–4