Operating With The Ac Power Adaptor Or Car Battery - Sony Walkman TCD-D100 Mode D'emploi

Operating with the AC Power Adaptor or
Car Battery
Tips
• When the AC power
adaptor or the car
battery cord is
connected to the DC IN
4.5V jack of the tape-
corder, the internal
batteries are
automatically
disconnected. Power is
automatically supplied
from the external
power source.
• When the AC power
adaptor or the car
battery cord is used for
an extended period of
time, the internal
temperature of the
tape-corder may rise.
This is not a
malfunction.
• If the unit is in the stop
mode for more than 10
minutes while using
the house current or a
car battery. The set
functions will be
canceled and the tape
will be unloaded for
tape protection.
36 EN
Power Sources
to DC IN 4.5V
Using the AC power adaptor
Connect the AC power adaptor AC-E45HG to the DC
IN 4.5V jack.
Notes on the AC power adaptor
• Use only the AC-E45HG AC power adaptor. Do not
use any other AC power adaptor.
Polarity of the plug
• Make sure that the cassette compartment lid is
closed before disconnecting the AC power adaptor
or removing the batteries. The cassette
compartment lid may not close if the power source
is disconnected or removed while the cassette
compartment lid is open. In this case, connect the
power adaptor or insert the batteries again.
Using the car battery
To operate the tape-corder with the car battery,
connect the car battery cord Sony DCC-E245 (not
supplied) to the DC IN 4.5V jack of the tape-corder.
For more details, refer to its Operating Instructions
manual.
AC power adaptor AC-E45HG