Setting The Clock - Sony Walkman TCD-D100 Mode D'emploi

Setting the Clock

Set the clock before starting any
recording operations to stamp
the date and time. Otherwise,
you cannot get the correct date
and time.
The clock will return to its
default setting (TU/97Y4M1D/
AM12H00M00S) if the batteries
are removed from the unit for a
long time. In this case, set the
clock again.
Make sure that the tape-corder is in the stop mode and that the HOLD function is off.
1
CLOCK/SET
2
–
3
CLOCK/SET
Tip
To set the clock accurately,
set the second to 00 with
the + or – button, and then
press the CLOCK/SET
button at the time of the
tone.
12 EN
Setting the Clock
Press the CLOCK/SET button for
more than four seconds.
Press + or – button to set the
+
current year, then press the
CLOCK/SET button.
Repeat step 2 to set the current
month, date, hour, minute. For
seconds, pressing + or – will set it
– +
to "00". Then press the CLOCK/
SET button.
The display stops flashing and
the clock operates.
To select either the 12-hour or 24-hour clock
display
Press the + button for 2 seconds or more.
To quit the clock setting
Press the p STOP button. The clock display will
return to the previous clock setting. However, if the
date is set , the year, month and date will be set and
will not be applicable for further cancellation.
HOLD
+
CLOCK/SET
–