Sony Walkman TCD-D100 Mode D'emploi page 14

Notes
• When making an
important recording, be
sure to use a tape with
enough recording time.
• The cassette holder will
not open if HOLD is
locked. Release HOLD
to insert a cassette.
• When inserting or
taking out a cassette, do
not hold the cassette as
shown below. This may
lead to a malfunction.
• Make sure that the
cassette compartment
lid is closed and
"UNLOAD" or "LOAD"
is not displayed before
disconnecting the power
source. Otherwise, the
cassette compartment
lid may not close. In this
case, connect the power
source again.
Tip
While the tape-corder is in
the stop mode, slide the
HOLD switch on the main
unit to HOLD to enter the
low-power consumption
mode manually when
using the unit on batteries.
(See page 34.)
* You can set the display,
clock or AVLS.
14 EN
Inserting the Cassette
To eject the cassette
While the tape-corder is in the stop mode, slide the
OPEN switch.
To protect your recording
Slide open the record-protect shutter to record-
protect your tape.
If the shutter is open, you cannot
record on the tape.
If the shutter is closed, you can
record on the tape.
Notes on DAT cassettes
• Unlike conventional analog cassettes, playback and
recording are applicable on one side of the cassette
only.
• Under normal usage, the construction of the DAT
cassette prevents undesirable entry of dust and
foreign particles. Do not open the DAT cassette
unnecessarily.
• Do not insert items into the holes on the reverse
side of the DAT cassette.
To prevent accidental operations
— HOLD function
Main unit: Slide the HOLD switch until the yellow
hold mark shows. When a button is
pressed in the HOLD mode, "HOLD" will
flash for 3 seconds in the display and the
buttons will be locked*.
Remote control: Slide HOLD switch in the direction
of the arrow. "H" will light up in the
display and the buttons will be locked.
OPEN