Patient Placement; Preparing For Patient Placement; Patient Transfer To Therakair Visio Mrs - arjo TheraKair Visio Manuel D'utilisation

Masquer les pouces Voir aussi pour TheraKair Visio:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 123

PATIENT PLACEMENT

TheraKair Visio MRS
i
Before placing a patient on the TheraKair Visio MRS, it is recommended that
personnel familiarize themselves with the information outlined in the Safety
Information section and Operation chapter of this manual as well as the procedures
outlined below.

Preparing for Patient Placement

1. Ensure that the system is set up as described in the Preparation for Use chapter of this
manual.
2.
3. Ensure that the system has been properly cleaned and disinfected, as detailed in the Care
and Cleaning section of this manual before a new patient is moved to the
TheraKair Visio MRS.
4. A clean set of air cushions and a clean cover sheet should be used for each new patient.

Patient Transfer to TheraKair Visio MRS

1. Press the InstaFlate button on the Home screen to access the InstaFlate screen.
2. Press the ON button on the InstaFlate screen to activate the InstaFlate function.
3. Raise / lower the height of the bed to the same level as the surface from which the patient
is being transferred.
4. Lower the side rails.
5. Transfer the patient to the TheraKair Visio MRS.
6. Center the patient on the mattress from side to side.
7. Raise the side rails on both sides of the bed and lock in place.
8. Press the OFF button on the InstaFlate screen to deactivate the InstaFlate function.
9. Exit the InstaFlate screen to return to the Home screen.
10. Adjust the bed height to its lowest level and adjust the head of the bed as needed for
patient comfort.
11.
29

Publicité

Table des Matières
loading

Table des Matières