Switching On/Off - HAIRCUT TH35 Manuel D'utilisation

3.1.2. Charging the clippers on the charger base
 Insert the electrical lead into the charger base socket (Fig. 2b).
 Insert the power pack in a mains power socket.
 Put the clippers on the charger base (Fig. 1-K).
 At the end of charging, the indicator light comes on steadily. The clippers can
then be used without the electrical lead.
3.2. OPERATION
When first used, lubricate the cutters by applying a drop of oil to the points
shown (Fig. 4).

3.2.1. Switching on/off

 Switch the clippers on by pressing the On/Off button (Fig. 1-B). The button
lights up.
 To stop the clippers, press the On/Off button again (Fig. 1-B). The button goes
out.
 When the clippers are not in use, it is advisable to clip the blade cover (Fig. 1-
O) onto the blade.
3.2.2. Use with or without electrical lead
 With a new, fully charged battery, the clippers can be used without the power
lead for about 120 minutes.
 Before the end of the autonomy period, the charge light flashes.
Charge the battery, refer to § 3.1.
 The clippers can be used with the electrical lead. For this, connect the cable to
the clippers (Fig. 2a) and connect the power pack (Fig. 1-L) to a mains power
socket.
25
EN