Dentsply Sirona CEREC AF Notice D'utilisation page 46

6 Installation and startup
44
Operating Instructions CEREC AF / AF Connect / AI / AI Connect / AI for Rear
NOTE
Possible data loss and PC malfunction:
Switching the PC off at the ON/OFF button during operation may
cause data loss and PC malfunctions.
➢ Always switch the unit off as described in the chapter "Switching
the units off [→ 45]".
2. Switch the monitor on.
Ä When the PC has started up and the coupling box is supplied
with voltage, the illuminated green LED on the camera cradle
indicates that the camera is ready for use. As long as the PC is
switched off, the camera and heater are not supplied with
power.
NOTE
The two USB ports on the front of the PC are also supplied with
power, if necessary, when the PC is switched off (depending on PC
hardware version).
➢ Always connect the coupling box to a USB power on the rear of
the PC.
3. Switch the milling unit on (see the Operating Instructions for the
milling unit).
4. After loading the operating system, start the "CEREC SW"
application by double-clicking on the "CEREC SW" button. Make
sure that the CEREC Omnicam is already connected when starting
"CEREC SW" . Subsequent disconnection and re-connection is then
possible without having to restart the "CEREC SW" .
5. For descriptions of further software actions, online help can be
accessed by pressing "F1" or via the Help... menu option.
NOTE
Internet Explorer V 5.0 or higher must be installed on your system in
order to use the online help function.
Connecting the PC monitor via HDMI
If you have connected your monitor to the PC via HDMI, it may be the
case that the image is surrounded by a black frame. In this case,
proceed as follows to correct it:
1. Right-click on the desktop and select "AMD Catalyst Control
Center" .
2. In the window that opens, select "My Digital Flat-Panels" on the left-
hand side and then select "Scaling Options (Digital Flat-Panel)"
from the sub-menu.
3. In the scaling options, move the slider to the far right to 0% and
save the changes.
Dentsply Sirona
66 37 487 D3652
D3652.201.01.19.02 10.2018