Preparing to install the refrigerator.
Read these instructions completely and carefully.
Water Supply to the Icemaker
If the refrigerator has an icemaker, it will have to be
connected to a cold water line.
Refrigerator Location
Do not install the refrigerator where the
temperature will go below 60°F (16°C)
because it will not run often enough to maintain
proper temperatures.
Clearances
Allow the following clearances for ease of
installation, proper air circulation and
plumbing and electrical connections:
Base Grille
Remove the base grille
by grasping it at the
bottom and pulling it
straight out.
Rollers
The rollers have 3 purposes:
Rollers adjust so the door closes easily when
1
opened about halfway. [Front of refrigerator
should be 1/4" (6 mm) higher than the rear of
refrigerator.]
Rollers adjust so the refrigerator is firmly
2
positioned on the floor and does not wobble.
Rollers allow you to move the refrigerator away
3
from the wall for cleaning.
(on some models)
A water supply kit (containing copper tubing,
shutoff valve, fittings and instructions) is available
at extra cost from your dealer or from Parts and
Accessories, 800-626-2002.
Install it on a floor strong enough to support it
fully loaded.
Sides . . . . . . . . . . . . . . . . . . . . . . . .1" (25 mm)
Top . . . . . . . . . . . . . . . . . . . . . . . . .1" (25 mm)
Back . . . . . . . . . . . . . . . . . . . . . . . . .1" (25 mm)
To replace the base
grille, align prongs on
back of grille with slots
in cabinet and push
forward until the grille
snaps into place.
To adjust the rollers:
Roller Adjustment Screw
(3/8" hex with slot)
Roller
Stabilizing
Brake
Remove the base grille.
Turn the roller
adjusting screws
clockwise to raise the
refrigerator, counter-
clockwise to lower it.
Use a 3/8" socket
wrench or adjustable
wrench. Replace the
base grille.
11