Preparing To Install The Refrigerator; Refrigerator Location - GE TCX18 Manuel D'utilisation

Preparing to install the refrigerator.

Read these instructions completely and carefully.

Refrigerator Location

Do not install the refrigerator where the
temperature will go below 60°F (16°C) because
it will not run often enough to maintain proper
temperatures.
Clearances
Allow the following clearances for ease of
installation and proper air circulation.
Sides 1" (25 mm)
Top 1" (25 mm)
/
Back* 1
1
*Metal cover on back may touch wall.
Packaging Tapes
Remove all packaging tapes and peel-off films.
These tapes were added to secure and protect
your refrigerator during transit.
Leveling
Your refrigerator comes with either adjustable rollers
or adjustable legs. Either rollers or legs should be set
so the refrigerator is firmly positioned on the floor
and the front is raised just enough that the doors
close easily when opened about halfway.
To adjust the rollers, tilt the base grille out exposing
the adjustment screws. Using an adjustable wrench,
turn the two front roller adjusting screws
counterclockwise to raise the refrigerator, clockwise
to lower it.
Adjustable
Roller
12
" (32 mm)
4
Base Grille
Turn adjusting screw
counterclockwise to raise
refrigerator
Install it on a floor strong enough to support it
fully loaded.
If refrigerator is to be installed against a wall on the
hinge side, allow a minimum of 1
between the wall and the side of the refrigerator to
allow for door and handle clearance.
Adjustable legs are located at the front corners.
Turn the adjustable legs clockwise to raise the
refrigerator, counterclockwise to lower it.
Tilt top out
/ " (45 mm)
3
4
Turn adjustment leg clockwise
to raise refrigerator
Adjustable
Leg