Reversing The Door Swing; Before You Begin; Tools Required - GE TCX22 Série Manuel D'utilisation

Preparing to install the refrigerator.
Read these instructions completely and carefully.
Stabilizing Brake
This refrigerator is equipped with a leveling foot
which serves as a stabilizing brake. This additional
leveling foot will hold the refrigerator securely in
position during operation and cleaning.
To set the brake, first remove the base grille and
hinge cover. Second, adjust the rollers to the
desired position. Then turn the stabilizing brake
until the brake is firmly in place against the floor.
After the brake is securely in place, unscrew the
roller adjustment bolt counterclockwise until the
weight of the refrigerator is supported by the
stabilizing brake. This allows the weight to be
positioned on the stabilizing brake.
Reinstall the hinge cover and replace the base grille.
Reverse the procedure to roll the refrigerator out.

Reversing the door swing.

Read these instructions completely and carefully.

Before You Begin

When reversing the door swing:
Read the instructions all the way through before
starting.
Handle parts carefully to avoid scratching paint.
Set screws down by their related parts to avoid
using them in the wrong places.
Provide a non-scratching work surface for
the doors.
IMPORTANT: Once you begin, do not move the
cabinet until door-swing reversal is completed.

Tools Required

Phillips screwdriver
Blade-type screwdriver
Masking tape
12
Roller Adjustment Screw
(3/8" hex with slot)
Roller
Stabilizing Brake
CAUTION: To avoid possible personal injury or
property damage the stabilizing brake must be
firmly touching the floor.
These instructions are for changing the hinges
from the right side to the left side—if you ever
want to change the hinges back to the right
side, follow these same instructions and reverse
all references to left and right.
5/16" hex socket driver
3/8" socket and ratchet
T15 Torx Driver
Bottom Hinge Cover