GE TCX22 Série Manuel D'utilisation page 14

Reversing the door swing.
Read these instructions completely and carefully.
Reversing the Hardware
Transfer Bottom Hinge Bracket to the Left
Remove the base grille by grasping it at
a
both ends and pulling it straight out.
Remove the bottom hinge bracket cover with
b
a flat screwdriver.
Use the ratchet wrench and socket to remove
c
the hex head screws and hinge bracket from
the bottom right side of the cabinet. Replace
the screws in the holes.
Remove the two outermost hex head screws
d
from the bottom left side of the cabinet.
Place the bottom hinge bracket over the
holes and tighten with the screws.
Move the hinge pin with the washer to the
e
hole that's now on the outside.
NOTE: It is important that the washer is on the
bottom of the hinge pin.
14
Bottom Right
Bottom Right
Bottom Left
Washer
Bottom Left