Power Led - Focal Professional TRIO11 BE Manuel D'utilisation

TRIO11 BE
U s e r m a n u a l
14 – FOCUS LED (front panel)
There are three possible states for the FOCUS LED:
- Off: the monitor is in standby mode or in 3-way mode
- Green: the monitor is in FOCUS mode
- Red: the monitor's heat protection is activated
15 – AUTO STAND-BY
Trio11 Be monitors are equipped with a selectable Standby mode. By default, the speakers are set to "ENABLE".
In this mode, Standby is activated. When you switch the speakers on, Standby mode is active. To exit Standby
mode, send an audio signal to the monitor, gradually increasing the sound level of the audio source. After
approximately 15 minutes without receiving an audio signal, the monitors automatically go into Standby mode.
In Standby, power consumption is less than 0.5 W.
Automatic Standby can be disabled. To do this, place the selector in the "DISABLE" position. When the
selector is in the "DISABLE" position, the speaker remains fully powered up at all times when the "ON-OFF"
switch is in the "ON" position.
I
> State of the Trio11 Be monitor
Colour

POWER LED

Illuminated
green
Illuminated red
FOCUS LED OFF
Illuminated
green
Illuminated red
™
State
Monitor ON
The limiter is activated Reduce volume
The monitor is in
3-way mode or
standby mode OR it is
in standby in FOCUS
mode
FOCUS mode
activated
Heat protection
Solution
-
Send an audio signal to turn on
OR
Press the footswitch to activate FOCUS
mode
Press the footswitch to activate 3-way mode
Reduce volume
26