Focal Professional TRIO11 BE Manuel D'utilisation page 20

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 6
TRIO11 BE
U s e r m a n u a l
Installation
Mains power
Your products absolutely must be grounded using the power cable.
Positioning
Trio11 Be monitors are near-field professional monitoring loudspeakers which require positioning facing the
listener at a distance between 1.5 and 4 meters (4.9 to 13.1 feet) They can perfectly be positioned on a
mixing console or they can be mounted to appropriate stands. Whichever position you choose, it is highly
recommended to place the tweeter at about the same height as the listener's ears.
Positioning of the rubber feet
Trio11 Be monitor speakers are supplied with 4 rubber feet so that the monitor can be detached from its
support (mixing console, stand...). We recommend positioning the rubber feet as to keep the distance
between them according to the dimensions of the support as big as possible (fig. B).
B
Orientation of the midrange/tweeter plate
The midrange/tweeter plate on the Trio11 Be monitor speaker can be rotated 360°, 90° at a time. This allows
the user to optimise the set-up according to the room acoustics and installation constraints.
Procedure for rotating the midrange/tweeter plate
1. Remove the 4 screws using the n° 4 Allen key (fig. C).
2. Pull the plate 10 cm out whilst inclining it (fig. D).
3. Using the vents, rotate the plate to the desired position. Check that the retention pins are in line with the
holes on the plate to ensure the screws are perfectly in line with the holes on the plate (fig. E).
4. For a proper implementation of the horn, always observe the following 3 points:
4.1. Position the horn. Place and tighten by hand the 4 screws respecting the order shown on the diagram
(fig. F).
4.2. Respecting the order in cross, tighten the screws again. Adjust the screwdriver on a low speed.
4.3. Still respecting the order in cross, tighten more. Adjust the screwdriver to a faster speed now. Then,
make sure the screws are tighten enough.
5. The monitor speaker is now ready to use.
C
D
E
20
F

Publicité

Table des Matières
loading

Table des Matières