Beko WMP 10744 XA Manuel D'utilisation page 31

Problem
Detergent residue in the detergent
drawer. (**)
Too much foam forms inside the
product. (**)
Foam is overflowing from the
detergent drawer.
When the Wash&Wear function is
selected, the laundry is still damp
at the end of the programme.
Laundry remains wet at the end of
the programme. (*)
(*) The product does not switch to spinning step when the laundry is not evenly distributed in the drum to prevent any damage to the
product and to its surrounding environment. Laundry should be rearranged and re-spun.
(**) Regular drum cleaning is not applied. Clean the drum regularly. See 4.4.2
A
WARNING:
the Authorised Service Agent. Never try to repair a nonfunctional product yourself.
Washing Machine / User's Manual
Cause
Detergent was put in wet drawer.
Detergent has gotten damp.
Water pressure is low.
The detergent in the main wash compartment got
wet while taking in the prewash water. Holes of the
detergent compartment are blocked.
There is a problem with the detergent drawer valves.
Detergent was mixed with the softener.
Regular drum cleaning is not applied.
Improper detergents for the washing machine is used. • Use detergents appropriate for the washing
Excessive amount of detergent is used.
Detergent was stored under improper conditions.
Some meshed laundry such as tulle may foam too
much because of their texture.
Detergent was put in the wrong compartment.
Softener is being taken early by the product.
Too much detergent is used.
Excessive laundry is loaded in.
Function is not active.
Excessive foam has occurred and automatic foam
absorption system has been activated due to too
much detergent usage.
If you cannot eliminate the problem although you follow the instructions in this section, consult your dealer or
Solution
• Dry the detergent drawer before putting in
detergent.
• Keep detergents closed in an environment free
of humidity and do not expose them to excessive
temperatures.
• Check the water pressure.
• Check the holes and clean if they are clogged.
• Call the Authorised Service Agent.
• Do not mix the softener with detergent. Wash and
clean the drawer with hot water.
• Clean the drum regularly. For this procedure,
please see "4.4.2 Cleaning the loading door and
the drum".
machine.
• Use only sufficient amount of detergent.
• Store detergent in a closed and dry location. Do
not store in excessively hot places.
• Use smaller amounts of detergent for this type
of item.
• Put the detergent in the correct compartment.
• There may be problem in the valves or in the
detergent drawer. Call the Authorised Service
Agent.
• Mix 1 tablespoonful softener and ½ l water and
pour into the main wash compartment of the
detergent drawer.
• Put detergent into the product suitable for the
programmes and maximum loads indicated in
the "Programme and consumption table". When
you use additional chemicals (stain removers,
bleaches and etc), reduce the amount of
detergent.
• Load a maximum of 1 kg when the Wash&Wear
function is selected.
• After the selected washing programme, check
if the Wash&Wear function has been selected
or not.
• Use recommended amount of detergent.
31 / EN