Equalizer Function; Setting The Clock; Auxiliary Mode - Ryobi R18RH Traduction Des Instructions Originales

the last volume setting used.
NOTE: If the AAA batteries are removed from the product
or have no charge, the volume will return to its default
settings.
■
To increase the volume, press
■
To decrease the volume, press
NOTE: To change volume quickly, hold
CAUTION
Do not use the product at maximum volume for an
extended period of time with the bass and treble at
maximum levels. It could cause damage to the speakers
and/or amplifi ers in the product.
FM/AM TUNING
See figure 3.
Use and to tune to the desired radio frequency. The
selected frequency is displayed on the LCD display.
To tune frequency manually:
Briefl y push either or
one frequency step at a time.
1. Press and release to tune to a lower frequency.
2. Press and release to tune to a higher frequency.
To tune frequency automatically:
1. Press and hold or
frequency automatically.
2. Press or to stop scanning and select a frequency.
To decrease interference or electrical noise, adjust the
position of the FM receptor or move the product to a higher
elevation.
STORING A PRESET IN MEMORY
See figure 3.
The memory feature saves up to 20 frequencies as
presets in the product's memory. You can save up to 10
frequencies each for FM and AM modes.
To store a frequency in memory:
1. Tune to the desired FM or AM frequency.
2. Press and hold
preset position number flash on the screen.
3. Press and to choose a preset position number.
NOTE: There are 10 preset positions for FM and 10
for AM. Only one station can be saved in each preset
4 | English
.
.
or .
(not press and hold) to tune
for one second to tune
until "MEMORY" and the
position.
4. Press again to store the frequency.
To tune to presets (FM or AM mode):
■
Press and release
preset position number and its associated frequency.

EQUALIZER FUNCTION

To adjust the bass and/or treble settings:
1. Press and hold
Press again and "t" (TREBLE) is displayed.
2. Press or until the desired bass or treble level
(–5 to 5) is achieved . Press
selection.

SETTING THE CLOCK

See figure 3.
Press to view the frequency in the digital display
for 10 seconds. The display will return to the current time
after 10 seconds.
NOTE: In all modes, the time is the default display.
To set the clock:
1. Press and hold
2. Press or to select the hour.
3. Press and release
Minute time blinks.
4. Press or to select the desired minute.
5. Press and release
The clock is now set.
NOTE: If AAA batteries are removed or lose charge for
more than 15 seconds, clock settings will be lost. Settings
are not affected by the removal of the 18 V battery.

AUXILIARY MODE

See figure 3, 4.
The product can be used as an amplifi er for MP3 players,
CD players, smartphones, tablets, and other music devices.
To use the auxiliary mode:
1. Press until AUX mode is highlighted.
2. Connect auxiliary cable (not included) to the device.
3. Connect the other end of the auxiliary cable to the
auxiliary input port.
NOTE:
– The external device must be on and in play mode
for sound to be heard through the speakers.
to cycle through each
until "b" (BASS) is displayed.
to store your
until the hour time blinks.
to lock in the hour setting.
again to confirm the time.