Input, Output And Control Section - dB Technologies VIO W15T Manuel D'utilisation

INPUT, OUTPUT AND CONTROL SECTION

1. USB SERVICE DATA
Using this standard type B USB port, you can update
the product's firmware using a PC and USB BURNER
MANAGER. For further information, refer to the
website http://www.dbtechnologies.com in the
"DOWNLOADS" section and the chapter
THE FIRMWARE.
2. SYSTEM TEST
With this control you can check the status of the
transducers using the integrated impedance test.
3. STATUS LEDs
The LEDs provide an immediate indication of the
status of the monitor, in accordance with the logic
summarised in the following table:
Power up
Use
Partial malfunction
Total malfunction CYCLIC FLASHING
4. RDNet NETWORK CONECTION INPUT AND LINKING, RDNet STATUS LEDS
Section compatible with network cables fitted with etherCON/RJ45 connectors. In particular:
•
"Data In" must be connected to devices such as RDNet Control 2 or Control 8
•
"Data Out" is used to link the network to other devices in a daisy-chain configuration
The LEDs indicate the network (RDNet) operating status of the monitor.
In particular:
•
"Link" illuminates to indicate that the RDNet network is active and has recognised the device
•
"Active" flashes to indicate the presence of data traffic
•
"Remote Preset Active" signals that all the local controls on the amplifier panel are bypassed
by the RDNet remote control
VIO W15T
24
UPDATING
Limiter Signal
OFF
ACTIVE ACTIVE
ACTIVE ACTIVE
R R D D N N e e t t
Expansion Card
1
USB Data Service
2
System
Test Status
Limiter
Signal
Status
ON
3
Status
STEADILY LIT FOR A
OFF
FEW SECONDS
OFF
CYCLICALLY LIT
OFF STEADILY LIT
PUSH PUSH
Remote
Preset Active
Active
Link
Data In
Data Out
Balanced Audio
P P U U S S H H
Input Output
Link
DSP Preset
Flat
Service/User
On
OFF
STEADILY LIT
STEADILY LIT
OFF
Cod. 420120335 REV. 1.0
English
4
5
6