Adjusting The Volume Of Subwoofer; Additional Information; Precautions - Sony HT-CT390 Mode D'emploi

3
When "LINK" appears in the top
panel display, press ENTER.
4
Press / to select "ON", then
press ENTER.
5
When "START" appears in the top
panel display, press ENTER.
"*****" appears, and the Bar Speaker
searches for a device that can be
used with Link. Proceed to the next
step within 2 minutes.
6
Press LINK on the subwoofer.
The power indicator on the
subwoofer flashes in orange.
7
When "DONE" appears in the top
panel display, press ENTER.
The subwoofer is linked to the Bar
Speaker and the power indicator on
the subwoofer turns orange.
If "FAIL" appears, check to ensure
the subwoofer is turned on and
press BACK to perform the process
again from step 3.
8
Press MENU.
The menu turns off.
Adjusting the volume of
subwoofer
The subwoofer is designed for playback
of bass or low frequency sound.
Press SW  +/– to adjust the
volume of subwoofer.
Note
When the input source does not contain
much of bass sound, such as in TV
programs, the sound from the subwoofer
may be difficult to hear.
22
US

Additional Information

Precautions

On safety
• Should any solid object or liquid fall into
the system, unplug the system and have
it checked by qualified personnel before
operating it any further.
• Do not touch the AC power cord (mains
lead) with wet hands. Doing so may cause
an electric shock.
• Do not climb on the Bar Speaker and
subwoofer, as you may fall down and
injure yourself, or system damage may
result.
On power sources
• Before operating the system, check that
the operating voltage is identical to your
local power supply. The operating voltage
is indicated on the nameplate on the
bottom of the Bar Speaker.
• If you are not going to use the system for
a long time, be sure to disconnect the
system from the wall outlet (mains). To
disconnect the AC power cord (mains
lead), grasp the plug itself; never pull the
cord.
• One blade of the plug is wider than the
other for the purpose of safety and will fit
into the wall outlet (mains) only one way.
If you are unable to insert the plug fully
into the outlet, contact your dealer.
• AC power cord (mains lead) must be
changed only at a qualified service shop.
On heat buildup
Although the system heats up during
operation, this is not a malfunction.
If you continuously use this system at high
volume, the system temperature at the
rear and bottom rises considerably. To
avoid burning yourself, do not touch the
system.