Settings And Adjustments; Using The Setup Display - Sony HT-CT390 Mode D'emploi

Settings and Adjustments

Using the setup display

You can set the following items with the menu.
Your settings are retained even if you disconnect the AC power cord (mains lead).
1
Press MENU to turn on the menu in the top panel display.
2
Press BACK///ENTER repeatedly to select the item and press ENTER to
select the setting you want.
3
Press MENU to turn off the menu.
Menu list
The default settings are underlined.
Menu items
"LVL >" "ATT"
(Level) (Attenuation
settings - Analog)
"DRC"
(Dynamic range
control)
"SPK >" "PLACE"
(Speaker) (Speaker
placement)
"AUD >" "DUAL"
(Audio) (Dual mono)
"TV AU"
(TV audio)
"EFCT"
(Sound effect)
"STRM"
(Stream)
16
US
Function
Distortion may occur when you listen to a device connected
to the ANALOG IN jack. You can prevent distortion by
attenuating the input level on the system.
• "ON": Attenuates the input level. The output level will
decrease at this setting.
• "OFF": Normal input level.
Useful for enjoying movies at low sound volume. DRC
applies to Dolby Digital sources.
• "ON": Compresses sound in accordance with the
information contained in the content.
• "OFF": Sound is not compressed.
• "STDRD": Select this setting if you install the Bar Speaker
in standard position.
• "WALL": Select this setting if you mount the Bar Speaker
on a wall (page 20).
You can enjoy multiplex broadcast sound when the system
receives a Dolby Digital multiplex broadcast signal.
• "M/S": Mixed sound of both the main and sub languages
will be output.
• "MAIN": Sound of the main language will be output.
• "SUB": Sound of the sub language will be output.
• "AUTO": Select this setting when the system is connected
to an HDMI (ARC) jack of a TV with an HDMI cable.
• "OPT": Select this setting when the system is connected to
a TV with the optical digital cable.
• "ON": The sound of the selected sound field is played. It is
recommended to use this setting.
• "OFF": The input source is down-mixed for 2 channels.
Shows the current audio stream information.
See page 28 on the supported audio formats.