Recommandations For Use - Atlantic F617 Notice D'utilisation Et D'installation

a) Detach the device from its wall bracket.
b) On the back of the thermostat box, detach pins P
from their supports.
c) Choose position N to lock the thumb-wheels or
position L to limit the range of use of the thumb-
wheels.
Choose one of the positions M to lock the person in
the desired mode.
Programming mode
The device is fitted with a thermostat that can be controlled via the control wire. It reco-
gnises the following commands:
- COMFORT : Temperature set using the thumb-wheel B
- COMFORT -1°C : Temperature set using the thumb-wheel B -1°C
- COMFORT -2°C : Temperature set using the thumb-wheel B -2°C
- ECO : Comfort temperature lowered approx. 3°C to 4°C.
- FROST FREE : Ambient temperature maintained at around 7°C.
- STOP : Stopping the heating immediately (used for power cutoff).
To activate Programming mode, set cursor A to
The device will then respond to a programming device for selection of the Comfort and
Eco temperature periods by connecting the control wire to a programming unit or another
device fitted with a time clock to save on energy.
NB: If no commands are received via the control wire, the device operates in Comfort
mode.The frost-free and power interruption commands are prioritised over the Eco and
Comfort modes. When switching from Comfort to Eco mode, the switchover time is around
12 seconds.
Frost warning
Your device is equipped with a function to alert you when your room temperature is below
3 ° C. In this case the red light flashes.
We recommend that you put your device in
room

Recommandations for use

- There is no point in setting the unit to its maximum, the room temperature will not rise
any faster.
- When you air the room, switch the unit off by putting cursor A to
Remember to lower the temperature if you go out for several hours.
If go out for : less than 2 hours, do not touch the controls.
from 2 hours to 24 hours, set the cursor A to
for more than 2 hours or during the summer, put the unit in Frost Free mode .
- If you have several units in the room, let them all operate at the same time, this will give a
more uniform temperature without in-creasing electricity consumption.
P
.
mode to avoid any risk of damage to your
17
A
B
M
N
L
.
.
EN