Push in the button located on the straight shaft trimmer
attachment. Align the button with the guide recess on the
power head coupler and slide the two shafts together.
Rotate attachment shaft until button locks into the posi-
tioning hole.
NOTE: If the buttons do not release completely in the
positioning holes, the shafts are not locked into place.
Slightly rotate from side to side until the button is locked
into place.
Tighten the knob securely.
WARNINg:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNINg:
Always wear safety goggles or safety glasses with side
shields when operating power tools. Failure to do so
could result in objects being thrown into your eyes
resulting in possible serious injury.
WARNINg:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this product for the purpose listed below:
Trimming grass and weeds from around porches, fences,
and decks
INSTALLINg STRINg IN PRO CUT II STRINg
hEAD
See Figure 4.
Use monofilament string between .095 in. and .105 in. di-
ameter. Use original manufacturer's replacement string for
best performance.
ASSEMbLY
WARNINg:
Be certain the knob is fully tightened before operating
equipment. Check it periodically for tightness during use
to avoid serious injury.
REMOVINg ThE ATTAChMENT fROM ThE
POWER hEAD
For removing or changing the attachment:
Stop the engine.
Loosen the knob.
Push in the button and twist the shafts to remove and
separate ends.
OPERATION
insert strings tHroUgH slots Until
approx. 1 in. protrUdes from Holes
pUll strings
from Holes
to remove
Stop the engine and disconnect the spark plug wire.
Gather two of the pre-cut lengths of trimmer line provided
or cut two pieces of trimmer line in 11 in. lengths.
Insert the strings into the slots located on the sides of
the string head. String should be pushed in until approxi-
mately 1 in. protrudes from the holes on the top of the
string head.
Remove old string by pulling it from the holes located on
the top of the string head.
7 — English
Hole
slot
slot
Hole
Fig. 4