Husqvarna PG 690 Propane Manuel D'utilisation page 5

1. Push the menu button quickly to move between the
selections in the display.
2. Push and hold the menu button to go to the selected
selection.
3. In the selection, push the menu button quickly to
select between ON/OFF.
4. In the selection, push the set button to adjust the
selected selection.
5. Push and hold the menu button to lock the selection
and go back to main menu.
Note: The display goes back to the main menu if you do
not use it for 10 seconds.
Display menu
Menu Information and ba-
selec- sic set
tions
Total op- Shows the time the
eration product has been
time used.
Time to Shows how many
next hours before a serv-
servicing icing is necessary.
Max rpm Shows the maxi-
mum rpm used dur-
ing last operation.
Ignition Basic set is "1P1r".
Rpm limit Set rpm range be-
tween 2000 - 3600
rpm.
Rpm Basic set is "OFF".
warning
Set is "ON", the
product gives a
warning at selected
rpm value.
Service Basic set is 100 h.
warning
The product gives a
warning when it has
been used for this
many hours.
Voltage Basic set is 11.0 V.
warning
The product gives a
warning at this volt-
age value.
1212 - 002 - 24.10.2019
Set options
N/A
Select "ON" to reset.
Select "ON" to clear.
N/A
Push the set button
quickly to add 100
rpm each time. Push
and hold the set but-
ton to add 1000 rpm
each time.
Push the set button
quickly to add 100
rpm each time. Push
and hold the set but-
ton to add 1000 rpm
each time.
Push the set button
quickly to add 1 h
each time. Push and
hold the set button
to add 10 h each
time.
Push the set button
quickly to add 0.1 V
each time. Push and
hold the set button
to add 1 V each
time.
Menu Information and ba-
selec- sic set
tions
Battery Shows the meas-
voltage ured voltage of the
battery in V.
Reset to Will reset the prod-
factory uct to factory set-
settings tings.
Display warning symbols
The display can show warning symbols.
• Rpm warning: The display shows a warning triangle.
• Low battery warning: The display shows the letters
LOU and a warning triangle.
• Service warning: The display shows the letters SUC
and a warning triangle.
Rpm for the engine
The display shows the rpm for the engine (A). The
gauge (B) in the display shows how much of the rpm for
the engine that is used.
A
The gauge has 3 fields of different color:
• Orange field: idle speed, 0 - 1200 rpm.
• Red field: the clutch engages, 1200-2000 rpm.
CAUTION: Do not operate the product
between 1200 - 2400 rpm. The clutch
can disengage.
• Green field: operate the product, 2400 - 3600 rpm.
Rpm for the grinding discs
The speed of the grinding discs is related to the speed
of the engine. The gauge (B) in the display shows how
much of the rpm for the engine that is used. The table
(A) below the display shows the rpm for the grinding
discs in relation to the rpm for the engine. When the
product is operated at maximum engine speed, 3600
rpm, the grinding discs speed is at maximum 1010 rpm.
Set options
N/A
Do not use.
rpm
B
Disc
675 840 1010
5