2. Remove the oil drain plug.
3. Drain the oil into the container.
4. Attach the oil drain plug and tighten it.
5. Fill with new oil. Refer to
29 .
6. Start the engine and let it run at idle speed for 3
minutes.
7. Stop the engine and make sure that the oil drain plug
does not leak.
8. Do a check of the oil level. Refer to
the oil level on page 22 .
Note: For safe disposal of used engine oil, refer to
Disposal on page 27 .
To replace the oil filter
1. Drain the engine oil, refer to
oil on page 22 .
2. Turn the oil filter counterclockwise to remove it.
3. Lightly lubricate the rubber seal on the new oil filter
with new oil.
1212 - 002 - 24.10.2019
Technical data on page
To do a check of
To replace the engine
4. To attach the oil filter, turn it clockwise until the
rubber seal is in position. Tighten the oil filter ⅔ turn
more.
5. Fill with new oil. Refer to
29 .
6. Start the engine and let it operate at idle speed for 3
minutes.
7. Stop the engine and make sure that the oil filter does
not leak.
8. Do a check of the oil level.
To replace the air filters
CAUTION: Do not operate the product with
the air filters removed.
Note: Do not clean the air filters. Replace the air filters
when it is necessary.
1. Open the 2 clamps (A) of the air filter housing (B)
and remove the air filter housing.
A
B
2. Replace the outer air filter (C) and the inner air filter
(D).
D
C
3. Install the new air filters in opposite sequence.
Technical data on page
23