Husqvarna PG 690 Propane Manuel D'utilisation page 15

• Servicing position of the handle:
To adjust the handle and the handlebar
WARNING: Be careful when you adjust the
handle and the handlebar. Make sure that
the handle and the handlebar locks into
position. The moving parts can cause injury.
Set the handle height as close as possible to the height
of the operators hip. During operation the product can
pull to the side. The hip of the operator can help to stop
this movement to the side.
1. Pull the lock lever (A) on the handle in the direction
of the control panel and hold it in this position.
A
2. Adjust the handle (B) to an applicable operation
height.
3. Release the lock lever on the handle to lock the
handle position.
1212 - 002 - 24.10.2019
B
4. Loosen the 4 screws (C) on the handlebar.
C
5. Adjust the handlebar (D) to an applicable operation
height.
6. Tighten the 4 screws (E) on the handlebar to lock the
handlebar position.
To connect the battery
• Make sure that the wires are firmly connected to the
correct terminals, red (+) first, black (-) second.
Disconnect the battery in reverse order.
• Make sure that the bracket that holds the battery in
place is correctly assembled, so that the battery
can't move during operation.
To connect and disconnect the propane
tank
CAUTION: Make sure to use the correct
propane tank type. An incorrect propane
tank can cause damage to the product.
Technical data on page 29 .
Refer to
If the propane tank is connected and the product is not
in operation, close the propane tank valve.
E
D
15