Removal And Installation - AGV PISTA GP RR Mode D'emploi

1
2
2
1
16 16
9 CROWN PAD
9.1 REMOVAL
AND INSTALLATION
Prerequisite: sit down with the helmet upside-down
on your knees.
To remove the crown pad, unfasten the two
→
front (1) and the rear (2) snap buttons.
To install the crown pad, fasten the two front
→
(1) and the rear (2) snap buttons.
Before removing the crown pad, make
sure that all the snap buttons have been
unfastened to avoid pulling on the seams
of the fabric parts.
Removing the crown pad is easier if the
cheek pads and wind protection have been
removed from the helmet beforehand.
10 WIND
PROTECTION
10.1 REMOVAL
Prerequisite: sit down with the helmet upside-down
on your knees.
To remove the wind protection, pull it by grasp-
→
ing its central area, then detach it from the
helmet by pulling out the plastic hooks. First
the side ones (1), then the central ones (2).
10.2 INSTALLATION
Prerequisite: sit down with the helmet upside-down
on your knees.
To install the wind protection, install the plas-
→
tic hooks in their slot inside the chinguard. First
the central ones (2), then the side ones (1).
11 360° ADAPTIVE FIT
The kit, in combination with the upper foams of the crown pad, allows you to customise
the setup and fit of the helmet on the head according to the riding style you adopt.
Please refer to the illustrative document included in the package of the 360° Adaptive Fit.
EN
IT
FR
DE
ES
PT
РУ
中文 中文 中文
17