Operation; "Info" Screen; Differential (Analysis) - Trotec PC200 Manuel D'utilisation

Operation

Switching on
1. Hold down the "On/Off" button
– The device is ready to go as soon as the start screen with the word
"PARTICLE" is shown.
Operating elements
The following operating elements are available:
Use the buttons to select a menu item.
Press "ENTER" to confirm your selection.
Press "ESC" to return to the previous menu at any time.
Use the "F1", "F2" and "F3" buttons to select various functions regardless of the
current screen.
Set language
1. Press "F2" in the start screen.
– The "SYSTEM SET" menu opens.
2. Press twice and confirm by pressing "ENTER".
– The "Language" menu opens.
3. Use the buttons to select the appropriate language.
4. Press "ESC" twice.
Start screen
You can open the following menus from the start screen:
"F1" button
"F2" button
"F3" button
"ENTER" button
MEMORY SET – saved data
The following submenus are available in the "MEMORY SET" menu:
Picture
Video
Particle Logs
SYSTEM SET – system settings
The following submenus are available in the "SYSTEM SET" menu:
Date/Time
Font Colour
Language
Brightness
Auto Power Off
Display Timeout
Alarm Select
Memory Status
Factory Setting
Units (°F/°C)
B - 4
until the colour display starts.
–
MEMORY SET saved data
–
SYSTEM SET system settings
Info - Information about the device
"Measurement" screen
Show images
Show videos
Show measurement logs
Set date and time
Set font colour
Set language
Set screen brightness
Set automatic switch-off
Set automatic display switch-off
Enable/disable alarm
Display memory use
Reset to factory settings
Switch unit for temperature

"Info" screen

This screen shows both information about the particle counter and also general
information about particle measurement. Use the "F1" and "F3" buttons to scroll
through the screens.
"Measurement" screen
The "Measurement" screen contains the following information:
26
25
24
23
22
16. Battery indicator
18. Indicator scale for particle bur-
den
20. Relative humidity
22. Dew point
24. Device status
Measurement is on
Measurement held
26. Date and time
You can open the following menus from the "Measurement" screen:
"F1" button
"F2" button
"F3" button
"RUN/STOP" button
Operating manual – Particle counter PC200
17. Start delay
Measurement duration
Measurement interval
19. Size and amount of particles
21. Wet-bulb temperature
23. Temperature
25. Method of analysis:
Cumulative
Differential
Concentration
Take a photo/record a video
–
MEMORY SET saved data
–
PARTICLE SET measurement settings
Start a new measurement
16
17
18
19
20
21
GB