Sharp PN-655U Mode D'emploi page 33

■ MODE SELECT 2
[OFF TIMER]
Function
Adjustable range 0 - 23 (hours)
Default
[OSD H-POSITION]
Function
How to adjust
Default
[OSD V-POSITION]
Function
How to adjust
Default
[ID No. SET]
Function
Adjustable range 0 - 255
Default
Note
[LANGUAGE]
Function
Available languages
Default
Specifies the remaining time before turning off the power (entering standby mode)
(see page 21).
0
Adjusts the horizontal display position of menu screen.
Use / to move menu screen.
Center
Adjusts the vertical display position of menu screen.
Use / to move menu screen.
Center
Assigns ID numbers to monitors connected in a daisy chain (see page 38), using
RS-232C cables.
0
The numbers 1 to 255 are available for ID numbers. (If "0" is set, the system
regards this as the state where no ID number is set.) Although numbers up to 255
can be used for monitor IDs, the number of connectable monitors varies depending
on the length of RS-232C cables and the installation environment.
Use / to increase or decrease values.
Switches the OSD language.
ENGLISH / DEUTSCH / FRANÇAIS / ITALIANO / ESPAÑOL
ENGLISH
31
E