Options - Zanussi ZDT 13011FA Notice D'utilisation

1)
Programme
3)
4)
5)
1) The water pressure and temperature, the variations of the mains supply, the options and the quantity of
dishes can change the programme duration and the consumption values.
2) This programme has a high temperature rinsing phase for better hygiene results. During the rinsing phase,
the temperature stays at 70 °C for 10 to 14 minutes.
3) With this programme you can wash a load with fresh soil. It gives good washing results in a short time.
4) This is the standard programme for test institutes. With this programme you have the most efficient use of
water and energy consumption for crockery and cutlery with normal soil. Refer to the supplied leaflet for test
information.
5) Use this programme to quickly rinse the dishes. This prevents the remaining food to bond on the dishes and
bad odours to come out from the appliance.
Do not use detergent with this programme.

Options

Acoustic signals
The acoustic signals operate in these condi-
tions:
• When the programme is completed.
• A malfunction occurs to the appliance.
Factory setting: on.
You can deactivate the acoustic signals.
Deactivating the acoustic signals
1. Press the on/off button to activate the appli-
ance.
2. Make sure that the appliance is in setting
mode. Refer to 'SETTING AND STARTING
A PROGRAMME'.
3. Press and hold the programme button until
the programme indicator (A) flashes and the
programme indicator (B) comes on.
4. Press immediately the programme button.
www.zanussi.com
Degree of soil
Type of load
Normal soil
Crockery and cut-
lery
Fresh soil
Crockery and cut-
lery
Normal soil
Crockery and cut-
lery
All
Programme pha-
ses
Wash 65 °C
Rinses
Dry
Wash 65 °C
Rinse
Prewash
Wash 50 °C
Rinses
Dry
Prewash
• The programme indicator (A) comes on
with a fixed light.
• The programme indicator (B) starts to
flash.
5. Wait until the programme indicator (A) goes
off and the end indicator comes on (the
programme indicator (B) continues to flash).
• The acoustic signals are on.
6. Press the programme button. The end indi-
cator goes off.
• The acoustic signals are off.
7. Deactivate the appliance to confirm the set-
ting.
Activating the acoustic signals
1. Refer to 'Deactivating the acoustic signals',
step (1) through (4).
2. Wait until the programme indicator (A) goes
off. The end indicator is off and programme
indicator (B) continues to flash.
Duration Energy
(min) (kWh)
105 - 115 1.6 - 1.9
30 0.8
130 - 140 1.0 - 1.2
12 0.1
Water
(l)
18 - 20
9
14 - 16
5
17