Zanussi ZDT 13011FA Notice D'utilisation page 21

1. Adjust the water softener to the lowest lev-
el.
2. Set the rinse aid dispenser to the lowest
position.
If you stop to use the combi detergent
tablets, before you start to use separately
detergent, rinse aid and dishwasher salt,
do these steps:
1. Press the on/off button to activate the appli-
ance.
2. Set the water softener to the highest level.
3. Make sure that the salt container and the
rinse aid dispenser are full.
4. Start the shortest programme with a rinsing
phase, without detergent and without
dishes.
5. Adjust the water softener to the water hard-
ness in your area.
6. Adjust the released quantity of rinse aid.
Setting and starting a programme
Setting mode
The appliance must be in setting mode to ac-
cept some operations.
The appliance is in setting mode when, after
the activation, all the programme indicators are
off and the end indicator flashes.
If the control panel shows other conditions,
press and hold the programme button until the
appliance is in setting mode.
Starting a programme without delay start
1. Open the water tap.
2. Press the on/off button to activate the appli-
ance. Make sure that the appliance is in set-
ting mode.
3. Press continuously the programme button
until the indicator of the programme you
want to set comes on.
4. Close the appliance door. The programme
starts.
Starting a programme with delay start
1. Set the programme.
www.zanussi.com
2. Press the delay button to delay the start of
the programme of 3 hours. The delay indi-
cator comes on.
3. Close the appliance door. The countdown
starts.
• When the countdown is completed, the
programme starts.
Opening the door while the appliance
operates
If you open the door, the appliance stops.
When you close the door, the appliance contin-
ues from the point of interruption.
Cancelling the delay start while the
countdown operates
1. Open the appliance door.
2. Press the delay button, the delay indicator
goes off.
3. Close the appliance door. The programme
starts.
Cancelling the programme
1. Open the appliance door.
2. Press and hold the programme button until
the indicator of the set programme goes off
and the end indicator flashes.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
At the end of the programme
When the programme is completed, an inter-
mittent acoustic signal operates and the end in-
dicator comes on.
1. Press the on/off button to deactivate the
appliance.
2. Close the water tap.
21