Zanussi ZDT 13011FA Notice D'utilisation page 19

Manual adjustment
1
Electronic adjustment
1. Press the on/off button to activate the appli-
ance.
2. Make sure that the appliance is in setting
mode. Refer to 'SETTING AND STARTING
A PROGRAMME'.
3. Press and hold the programme button until
the programme indicator (A) starts to flash
and the programme indicator (B) comes on.
4. Wait until the programme indicator (B) goes
off and the end indicator starts to flash (the
programme indicator (A) continues to flash).
5. Press the programme button.
• The end indicator flashes intermittently.
The number of flashes shows the level of
the water softener, e.g. 5 flashes +
pause + 5 flashes = level 5.
6. To adjust the level of the water softener,
press the programme button. Each time you
press the programme button you go to the
next level.
7. Deactivate the appliance to confirm the set-
ting.
Filling the salt container
Caution! Water and salt can come out
from the salt container when you fill it. Risk
of corrosion. To prevent it, after you fill the salt
container, start a programme.
www.zanussi.com
2
Turn the water hard-
ness dial to the posi-
tion 1 or 2.
1
3
Put 1 litre of water in
the salt container (on-
ly for the first time).
5
Filling the rinse aid dispenser
1
2
4
6
2
19