Operation - Sony WRR-800A Mode D'emploi

Operation

1
ANTENNA A, B
3
4
5
+
–
UHF
synthesized
wireless
microphone
1
Connect the supplied antennas and make the antenna
tips point upward.
2
Connect the supplied AC power adaptor to the DC IN
9V connector and an audio mixer or amplifier to the
TUNER OUTPUT connector.
12
2
DC IN 9V
AC power adaptor
TUNER OUTPUT
Audio mixer, amplifier
UHF synthesized
transmitter
3
Turn the POWER switch on.
Note
Turn the POWER switch on after reducing the volume
of the equipment connected to the TUNER OUTPUT
connector. Otherwise, noise will be heard when the
POWER switch is turned on.
4
Set the reception channel.
For details on setting the channels, see page 13.
5
Turn on the wireless microphone or transmitter.
Use the wireless microphone or transmitter to which the
same channel is assigned as to this unit.
If noise is heard
Depending on the environment where the system is
installed, outside noise or radio wave may disrupt the
transmission of certain channels.
To select a channel under this circumstance, turn off the
wireless microphone or transmitter. Then select a channel at
which the RF indicator is off. (A channel free from noise or
radio wave interference is selected.) Set the same channel on
the microphone or transmitter.