Publicité
Les langues disponibles
Les langues disponibles
Winemaster C50S(SR) USER MANUAL
3.4. DEFROSTING
3.5. VIBRATION ELIMINATION
The vibration of the compressor is controlled in two ways:
The compressor sits on flexible rubber blocks (silent blocks).
The Winemaster is surrounded in its frame by these silent blocks.
Please note: In wooden frame cellars it is very important to store the wine bottles on shelves standing on the floor
of the cellar, NOT on shelves fixed to the walls.
3.6. SECURITY
The compressor is equipped with a safety thermostat which detects any irregular increases in the compressor
temperature. In the case of a dangerous temperature, the compressor automatically shuts down. In the event of
poor ventilation where the air inside the cellar becomes too warm, the C50-S automatically speeds up the ventila-
tion and heat exchange system to obtain the desired temperature and air circulation.
4. ELECTRONIC CONTROL PANEL
set, press the button
PRG
-
INDICATOR SET 2 flikering = cold mode on standby
-
INDICATOR SET 2 lit fixed = engaged cold mode (compressor)
-
INDICATOR SET1 flikering = heat mode on standby
-
INDICATOR SET1 lit fixed = heat (resistance)
5. POSITIONING OF THE WINEMASTER
The WINEMASTER should be installed into a wall with one side of the unit facing the interior of the cellar and the
other side facing the exterior of the cellar on the other side of the wall. This means that the exterior side of the unit
must be accessible from outside of the cellar - see item 6 "WINEMASTER Wall Installation." This allows for the pro-
duction of cool air within the cellar by keeping all warm components on the exterior side of the wall.
15
The WINEMASTER C50-S/(SR) defrosts automatically by shutting down the compressor for 7
minutes each hour.
3
to confirm it.
The WINEMASTER is equipped with an electronic ther-
mostat placed on the front of the unit which permits you to
view the mode of operation inside the cellar at any time
from the exterior of the cellar. In addition, the thermostat
5
continues to display the precise temperature inside of the
cellar.
The on/off button IOII (reference 1 in diagram) al-
lows you to start the air conditioner and select the
level of ventilation within the cellar.
4
The button IO (reference 2) when lit up in green
indicates the electricity connection of the unit and
1
allows you to illuminate the integrated flourescent
lamp.
The setting of the targeted temperature of the cellar is
made on the thermostat .
Use the following process :
2
Press the button
o1 appears. Press then the button PRG, the set
temperature of the cellar will appear. Use again the button
to increase the temperature or the button
SET 1
to lower the temperature. When the right temperature is
one seconde until the message
SET 1
08/2007
SET 2
Publicité
Chapitres
