Télécharger Imprimer la page

Characteristics; Capacity; Temperature Regulation; Humidity Regulation - WINEMASTER WINE C50 S Mode D'emploi

Masquer les pouces Voir aussi pour WINE C50 S:

Publicité

Les langues disponibles

Les langues disponibles

Winemaster C50S(SR) USER MANUAL
WINEMASTER units primarily cool the air inside the cellar but they are also equipped with a heater which maintains
an ideal temperature within the cellar even in the winter months.
An integrated electronic thermostat pilots the functioning of the unit and maintains the specific temperature selected
while the electronic control panel displays the current mode of operation.
3. WINE C50-S / (SR) CHARACTERISTICS

Capacity

Temperature Regulation

Maximum exterior temperature
Refrigeration Power
Power Supply
Electric power
Lighting
3.1. CAPACITY
Subject to adequate insulation, the WINEMASTER will maintain an ideal temperature in cellars of up to a maxi-
mum volume of 50 m³.
The chart on page 5 shows which types of insulation will provide the level of insulation necessary for your cellar.
In order for the WINEMASTER to function efficiently, the cellar must be thoroughly insulated and the cellar volume
must not be exceeded.
3.2 TEMPERATURE MAINTENANCE
The thermostat is preset at 12 °C and is adjustable between 2 and 20 °C, but it is strongly advised that the tem-
perature is not adjusted frequently.
The thermostat will maintain the temperature inside cellar within ±2 °C accuracy. The thermal inertia of the wine
and the glass is such that within this temperature range the temperature of the wine will only fluctuate between
0.2° and 0.3° C.
It is important to appreciate that there is a difference between the air temperature inside the cellar and the actual
temperature of the wine. The WINEMASTER creates perfect thermal stability.

3.3 HUMIDITY REGULATION

The refrigeration unit creates a constant cycle of condensation-evaporation within the cellar.
The humidity condensing on the evaporator is collected by the WINEMASTER. Then, some of this water is
evaporated, thus stabilising the cellar humidity between 65% and 80%. The excess water is then routed into a
drainage pipe which must be set into a container inside or outside of the cellar.
It is important to understand that the humidity cannot be completely stabilized, because it depends on exterior
conditions that vary widely according to the region, the season, and the weather. In particular cases of extremely
dry air, it may not be possible to sufficiently humidify the air.
IMPORTANT:
In order for accurate humidity regulation and efficient functioning of the WINEMASTER unit, you
will need:
Complete insulation of the cellar (walls, floor, ceiling, door) with an airtight seal.
Perfect continuity of the insulation (no gaps).
14
Cellars of volumes up to 50 m³
Preset at 12 °C with possibility of adjusting the temper-
ature between 4 to 25°C
1200 W at 15 °C
230 -240 V - 50 Hz with ground wire connection
(3 meter of cable)
Flourescent lamp with on/off switch on the unit
35 °C
900 W
08/2007

Publicité

Chapitres

loading

Ce manuel est également adapté pour:

Wine c50 sr