Cleaning The Spray Arms; External Cleaning; Troubleshooting - AEG FAVORIT 35400 I Notice D'utilisation

8.2 Cleaning the spray arms

Do not remove the spray arms.
If the holes in the spray arms are clog-
ged, remove remaining parts of soil with
a thin pointed object.

8.3 External cleaning

Clean the appliance with a moist soft
cloth.

9. TROUBLESHOOTING

The appliance does not start or it stops
during operation.
Before you contact the Service, refer to
the information that follows for a solu-
tion to the problem.
Alarm code
• The start indicator flashes continu-
ously.
• The end indicator flashes 1 time in-
termittently.
• The start indicator flashes continu-
ously.
• The end indicator flashes 2 times in-
termittently.
• The start indicator flashes continu-
ously.
• The end indicator flashes 3 times in-
termittently.
WARNING!
Deactivate the appliance before
you do the checks. Turn the pro-
gramme knob until the pro-
gramme marker is aligned with
the on/off indicator.
6. Assemble the filter (A) and put it in-
to position in filter (B). Turn it clock-
wise until it locks.
An incorrect position of the filters
can cause bad washing results
and damage to the appliance.
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning
pads or solvents.
With some problems, different indica-
tors flash continuously or intermittent-
ly at the same time to show an alarm
code.
Problem
The appliance does not fill with water.
The appliance does not drain the wa-
ter.
The anti-flood device is on.
ENGLISH
29