Bonnet Neve AGORA 4 ECO Instructions Pour L'utilisateur page 28

property. The manufacturer assumes no responsibility for such damages.
Make sure that power supply voltage corresponds to the values appearing on the rating plate of the
refrigerator. Consider also that the maximum allowable power voltage variation is +/-6%.
IMPORTANT: THE REFRIGERATOR MUST BE PROPERLY EARTHED. The manufacturer disclaims all responsibility
for damage resulting from non-observance of this safety principle. If the refrigerator must be installed far from
the power point, make certain that the connection complies with the standards in force.
THE MANUFACTURER DISCLAIMS ALL RESPONSIBILITY FOR ANY PERSONAL INJURY OR PROPERTY
DAMAGE ARISING FROM INCORRECT INSTALLATION.
6. TECHNICAL SPECIFICATIONS
The built-in electrical installation is composed of control and safety devices lodged in the base of the appliance. The
wiring diagrams and settings lists are contained in a sealed plastic envelope together with the present booklet. Keep
such documents with this booklet. The technical data, which are also reported on the rating plate inside the display
case (see fig. 15 on page 5) are shown on table III, page 5. The sound level generated by the running refrige-
rator is below 70 dB (A) . The refrigerator generates no harmful vibrations.
WE HEREBY DECLARE THAT THE SHOWCASE AT ISSUE COMPLIES WITH D.L. (DECREE LAW) DATED
25/JAN/1992 N° 108 AS EXECUTING ECC DIRECTIVE 89/109 ON MATERIALS AND OBJECTS FIT FOR
CONTACT WITH EDIBLES.
WE HEREBY DECLARE THAT THE SHOWCASE AT ISSUE IS ADEQUATE FOR THE PRESERVATION OF
FROZEN PRODUCTS IN COMPLIANCE WITH LAW No. 283 DATED 30/APRIL/42 AND SUBSEQUENT
AMENDMENTS, AND
26/MARCH/81 No. 85.
Thermostat adjustment is restricted to the technical after-sales service only.
7. LOADING PRODUCTS
Switch the cabinet on through the wall cutoff switch. As soon as the cabinet is on it will start its cooling cycle. Allow
about two hours before loading any products, which must already be at their preservation temperature. THE CABI-
NET IS FACTORY-REGULATED FOR THE ANTICIPATED PERFORMANCE.
When loading products make certain that:
• they are similar in size and type;
• the load limit line is not exceeded and products do not hamper correct cool air circulation (see fig. 18,
page 6).
8. USE
The showcase was designed and manufactured exclusively for the display of ice-creams and frozen food in its low-
temperature version (class L), of pre-packed fresh food in its positive temperature version (class M). Its function is
preserving food temperature, not lowering it. Therefore, when introduced, THE FOODSTUFFS MUST BE
AT THEIR CONSERVATION TEMPERATURE. Do not load foods that have undergone heating. Use padded
gloves when handling ice-creams and frozen food.
QUM000191E
DECREE LAW OF 29/JAN/81 PUBLISHED IN THE OFFICIAL GAZETTE dated
19