Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5.
Attach the attachment plate to the projector
1.
Place the projector upside down.
2.
Attach the attachment plate to the projector using the hexagonal wrench (M4) and five M4 × 12
mm bolts with washers/spring washers.
Attachment plate
Warning
When installing or adjusting the wall mount, do not use adhesives to prevent the screws from
loosening and do not use lubricants or oils on the projector slide plate. This may cause the
case to crack and the projector to fall, resulting in personal injury or property damage.
q
Tighten the screws firmly.
6.
Attach the projector to the adjustment unit
1.
Slide the attachment plate onto the adjustment unit as shown below.
2.
Partially tighten two M4 × 12 mm bolts at the points marked on the adjustment unit as shown
below.
M4 × 12 mm hexagon socket
head cap bolt with washer
Mark
Attachment plate
26
M4 × 12 mm hexagon socket head cap
bolt with washer/spring washer (×5)
Projector lens side
M4 × 12 mm hexagon socket head
cap bolt without washer
Adjustment unit
Publicité
Table des Matières
