Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3.
Route the cables through the arm unit
Route the projector's power cord and any additional cables connecting to the projector through the arm unit.
Be sure to also route the cables for any optional equipment (for example document
q
camera, speakers, etc.) that may be used in the future. Otherwise, each time you need
to connect another device, you will need to remove the projector from the mount to
connect additional cables.
Caution
Problems may occur if you use this product without routing the cables through the arm unit.
Route the USB cable so that the type B connector emerges on the projector side. Epson
q
recommends labeling any duplicate cables so that additional connections can be more
easily identified.
4.
Attach the wall mount to the wall plate
1.
Attach the hook on the arm plate to the bar on the wall plate.
2.
Partially tighten two M8 × 16 mm hexagon socket head cap bolts to secure the arm plate .
Caution
Take care not to trap the cables between the mount arm and wall plate.
Arm unit
Arm plate
Arm unit
25
Vertical adjustment
screw
Bar on wall plate
Wall plate
M8 × 16 mm
hexagon socket
head cap bolt (×2)
Publicité
Table des Matières
