Cleaning And Storage - Geoline MINI DIAPHRAGM GEOPUMP Instructions De Montage

Carry out the stopping operations described in the manual of the machine incorporating the motor
pump; unless otherwise indicated, for the motor pump you must remember the following.
a) Reset the delivery pressure as described in point a) of the paragraph "operation".
b) Disconnect the power supply.
c) Wait for the motor pump and the machine incorporating it to cool down.
WARNING
• When the motor pump and the machine incorporating it are cooled down, take care:
- not to leave them unguarded near unsupervised children, elderly or disabled people;
- to place them in a stable position without the risk of falling;
- not to place them in contact with or near inflammable materials.

CLEANING AND STORAGE

WARNING
• Pay special attention to the provisions of paragraph "WArninGs on pumped chemicAls".
• All cleaning must only be done having carried out the operations described in the paragraph
"stoppinG", that is to say with no moving parts, with no pipes full of pressurised liquid and
once it has cooled down.
In particular always remember to disconnect the power supply.
• All cleaning operations must be done in conditions of total stability.
• Do not use thinners or solvents for cleaning.
CAUTION
• Before cleaning and storing the motor pump remember to run it for a few minutes with clean water
in order to clean out the chemicals used from the pipes and the internal parts.
• Never leave the motor pump at rest with chemicals inside it.
• The motor pump can be damaged by frost.
In cold climates, in order to prevent ice from forming inside, before storing the pump suction in some
car antifreeze and then fully bleed it. If it is not possible to protect the motor pump as illustrated above,
before starting it place in a warm room for enough time to melt any ice which may have formed inside:
non­compliance with these simple instructions can cause serious damage to the motor pump.
WARNING
• Rinsing fluids and antifreeze must be disposed of appropriately; do not dispose of in the environment.
MAINTENANCE
WARNING
• Follow the maintenance instructions contained in the manual of the machine incorporating
the motor pump.
• All maintenance must be carried out only after having completed the operations described in the
paragraph "stoppinG", that is to say with no moving parts, with no pipes full of pressurised
liquid and once it has cooled down.
In particular always remember to disconnect the power supply.
• All maintenance operations must be carried out in conditions of full stability.
• WARNING. To guarantee the safety of the motor pump use only original spare parts supplied by the
Manufacturer or someone appointed by him.
U s e a n d M a i n t e n a n c e
6
EN
25