Geoline MINI DIAPHRAGM GEOPUMP Instructions De Montage page 24

supply, because when it cools down it could start up again automatically.
• WARNING. Do not use the motor pump or the machine incorporating it near people who are not
wearing protective clothing.
• WARNING. Do not direct high pressure jets at yourself or anyone else in order to clean clothing or
footwear.
• WARNING. High pressure jets may be hazardous if used improperly. High pressure jets must not
be directly towards people, powered electrical equipment or towards the motor pump itself or the
machine incorporating it.
• WARNING. Risk of explosion - Do not spray inflammable liquids.
• Do not use the motor pump in the rain.
• Pay special attention to the provisions of paragraph "checKs And connection to the poWer
line".
• Pay special attention to the provisions of paragraph "WArninGs on pumped chemicAls".
• Keep the power cable and any extension cables dry. Do not touch them with wet hands.
• Do not go near the moving parts of the motor pump or the machine incorporating it, even when
suitably protected.
• Do not remove the guard from the moving parts.
• Do not work on pipes containing pressurised liquids.
• Do not carry out maintenance on the motor pump and the machine incorporating it when they are
running.
• Comply with the provisions of paragraph "INTENDED use".
• Do not modify the installation conditions of the motor pump in any way, in particular do not modify
the fixings, hydraulic connections or guards.
• Do not disable or tamper with the commands or safety devices.
Carry out the operating functions described in the manual of the machine incorporating the motor
pump; unless otherwise indicated, concerning the motor pump you must remember the following.
a) The motor pump can be primed only by resetting the delivery circuit pressure, which can be done, for
example, by opening one or more taps on the machine incorporating the motor pump.
b) The pressure is adjusted from the device present on the machine incorporating the motor pump.
CAUTION
• To rapidly prime the motor pump, do as shown in point a) each time it needs to be re-primed.
• Do not run the motor pump:
- if it is too noisy and/or below it there are clear drips of fluid: in this case have it checked by a
Specialist Technician;
- in direct exposure to sunlight, with temperatures higher than 35 °C - 95 °F.
STOPPING, CLEANING AND STORING
WARNING
• Follow the instructions concerning stopping, cleaning and storage contained in the manual
of the machine incorporating the motor pump.
STOPPING
WARNING
• Always check that, having stopped the machine, no parts of the motor pump or the machine
incorporating it are moving and that there is no pressurised liquid in the pipes.
24
U s e a n d M a i n t e n a n c e
6
EN