Refilling The Water Softening Salt Reservoir; Changing The Air Filter - SciCan HYDRIM C61w G4 Manuel De L'utilisateur

6. Care and Maintenance

6.2 Refilling the water softening salt reservoir

When a red X appears on the detergent and water softener level indicator, press on
the icon to determine if the problem lies with the water softener or cleaning solution level.
If the water softener must be refilled, follow these steps:
2. Remove softener

6.3 Changing the air filter

HEPA filter
Page 32
1. Open the salt container lid.
2. Fill the salt container to the top, using
the funnel supplied, to a maximum of
0.5 kg.
3. Close the salt container lid, ensuring
a tight seal. An improper seal
can lead to corrosion.
4. Run a complete cycle, with no instruments.
Spare part#: 01-112594S Salt,
Water Softener
When the message "Replace air filter"
appears, the HEPA filter is in need of
changing. Turn the power off. Pull open the
ventilation panel below the front door of the
unit. Make note of the direction of the arrow
and remove the old filter by pulling it from
the centre. Install the new air filter – placing
the arrow in the correct orientation – and
close the ventilation panel.
After replacing the filter, go to the "Reset
Drying Counter" screen in the Setup menu
and reset the drying counter to zero. (See
Section 3.11)
The filter must be replaced every 750 drying
cycles. The unit will continue to run if the
filter is not replaced, but you will notice less
than optimal drying performance.
Spare part#: 01-113277S Filter-Air, C61