Setting Date; Assigning Unit Identifier Number; Resetting Drying Counter - SciCan HYDRIM C61w G4 Manuel De L'utilisateur

3. Setting up your HYDRIM
NOTE: If the HYDRIM is connected to a network, it is important to also enter the correct
Time Zone. Enter the Time submenu, select Time Zone and scroll and select your local
time zone.
4.
To change your unit to display 12-hour time format (24-hour time format is the default
setting), go to the Setup menu and use
toggle to 12. Press
5.
To activate daylight savings time (DST), go to the Setup menu and use
to DST ON/OFF and select. Use
to save and return to the Setup menu.
3.9 Setting the date
1.
2.
Scroll to
3.
From the DATE screen, use the keypad to set the date. Press
to return to the Setup menu.
4.
To change the format in which the date appears, return to the Setup menu and use
the date displayed in the desired format. Press
the Setup menu.

3.10 Assigning unit identifier number

1.
2.
Scroll to
3.
Using the keypad, select a maximum of 3 digits to be used as the unit's identifier
number. Press
3.11 Resetting the drying counter
The drying counter must be reset when the HEPA filter is changed. To reset the drying
counter, follow these steps:
1.
2.
Scroll to
3.
Select Default 0 to reset.
to save and return to the Setup menu.
Date and select.
to scroll to DATE FORMAT. Select it, and follow the prompts to have
Unit No and select.
to save and
EN
and select.
Reset Drying Counter
to scroll to TIME 12/24, select it and
to toggle DST ON or OFF and press the
to save and return to
to return to the Setup menu.
Page 13
to scroll
to save and
EN