Introduction - SciCan HYDRIM C61w G4 Manuel De L'utilisateur

1 Introduction

1 Introduction
Thank you for selecting the HYDRIM C61w G4 instrument washer. The HYDRIM
complements the STATIM
soiled instruments for sterilization. To ensure years of safe, trouble-free service, carefully
review this Operator's Manual before operating the unit. The HYDRIM C61w G4 is suitable
only for the applications listed in this manual. Using the HYDRIM for other purposes may
be dangerous. The manufacturer cannot be held responsible for damage caused by
improper use.
Operational, maintenance and replacement instructions must be followed for the product
to perform as designed. All trademarks referred to in this manual are the property of their
respective owners. Contents of this manual are subject to change without notice to reflect
changes and improvements to the HYDRIM product.
The HYDRIM should only be installed and serviced by a qualified contractor as the
HYDRIM C61w G4 is an Installation Category II device. Before connecting the unit, the
installer should check that the voltage and frequency of the electrical supply correspond
with the details in the installation instructions. The unit must only be plugged into a
grounded outlet. Please note that this unit is completely isolated from the electrical supply
only when it is unplugged or the circuit breaker is turned OFF. This must be done before
any repair work is carried out.
The HYDRIM C61w G4 uses HIP™ Ultra cleaning solution exclusively. The unit will not
perform as described if detergents or cleaning products not approved by SciCan are used.
Other detergents or cleaning products may damage the unit, the instruments, cause
excessive foaming, and void the warranty. Do not use solvents in this unit. Do not allow
unauthorized personnel access to this unit or its controls.
and BRAVO autoclaves by quickly and hygienically preparing
® ™
Page 3
HY DR IM C61 w