Replacing Parts/ Replacing The Hepa Filter; Replacing The Primary Filter - Nilfisk 118EXPW Instructions D'utilisation

REPLACING PARTS
REPLACING THE HEPA FILTER
1. Remove the wing nuts that secure the HEPA screen (Figure 1).
2. Pull off the screen surrounding the three posts.
3. Remove old HEPA cartridge by carefully pulling cartridge through the posts.
4. Remove the old foam gasket from around the exhaust port.
5. Place a new foam gasket around the exhaust port (Figure 2).
6. Carefully install new HEPA cartridge against the foam
gasket with the label facing out.
7. Reinstall the screen around the posts.
8. Tighten the wing nuts.

REPLACING THE PRIMARY FILTER

1. Release the latches "A" and remove the Motor Head "B" (Figure 3).
2. Remove the four screws "C" from the Diaphragm "D" (Figure 4)
3. Remove the Diaphragm "D" (Figure 5).
4. Remove the old Primary Filter "E" (Figure 5)
5. Install the new Primary Filter "E" inside a Cap "F" (Figure 5)
6. Reinstall the Diaphragm"D" and tighten the screws "C" (Figure 4).
8. Mount the motor head "B" onto the machine and secure
in place with the latches "A" (Figure 3).
9. Dispose of the old filter in accordance with all federal,
state and local regulations.
INSTRUCTIONS FOR USE
1
2
3
C
4
D
D
5
E
F
PAGE 6